Anet A8 Dual Mosfet Case
As you can see from the pictures the case is designed to sit at the bottom of the frame and intended to house 2 mosfets and the motherboard - oh! and with the added bonus of a reset button (which some other thingiverse user inspired me with.. thanks.. there design can be found here http://www.thingiverse.com/thing:2078881).
Case Size: 200mm x 135mm x 50mm with 1.6mm sides and faces.
Only Faceplate Test Printed so far...
I printed the faceplate with and without a brim and struggled to remove the brim from the inner hexes so i advise against it - though a brim shouldn't be a problem on the case back.
UPDATE
i have reprinted the front faceplate with a "brim" - i created a false brim using skirt so it applies to the outside of the faceplate only causing no silly hex brim! ...
To apply this false brim i set the skirt to 20 lines (this can be adjusted to suit) and i set the skirt distance to 0.01mm - good luck!
Any issues - problems or general input leave a comment and let me know - thanks - de-signz.co.uk