Bicycle printed on a UP! Mini.
It was intended as a trophy for being 12.5 years with the company.
I don't have a race bike nor intend to own one.
I took some information from the net about frames. From there I created a frame, the wheels and the rest. It came out that the front wheel should be smaller as the backwheel... so be it.
Known issues:
Play of the axles in their bearing could be reduced.
Play of the front fork in the frame is OK.
Play of the pedal-axle in the frame could be reduced.
To use an elastic band for a chain, carefully cut the right-rear leg from the frame, put the elastic band over the hubs, than glue it back in place.
The pedal-axles have a press fit into the kranks, holes in the kranks could be a bit larger.