this started as a remix, but i ended up retooling the whole design.
IMPORTANT!
for mounting there is only one screw hole for things to mount to.
i ended up placing this a bit higher on the power supply and drilled holes.
for this i took my power supply apart, and took the board out as to not have metal shavings left on it to cause a short. then once the holes were made i reassembled it.
(DO THIS AT YOUR OWN RISK)
Components:
- Inlet Male Power Socket with Fuse Switch 10A 250V 3 Pin IEC320 C14 AD
- 15 Ft 3 Prong IEC320C13 to NEMA5-15P Standard Universal AC Power Cord
My other Uploads:
Anet A8 Case: http://www.thingiverse.com/thing:2029528
Anet A8 Mosfet Case: http://www.thingiverse.com/thing:2054199
Y Chain: http://www.thingiverse.com/thing:2043493