- Complete new and own design, therefore different from any other capsule holder on thingiverse
- Small amount of material needed (it's very cheap)
- Therefore fast printing time (you can make a lot of them)
- 2 parts to be combined with dovetail (for perfect alignment)
- Optimized capsule movement through elevated sliding rail (bulge on the flat side does not lead to stuck capsules)
- Ability to take out capsules at the bottom
- Space for 10 capsules
- Printing footprint: about 18x10cm
Note: This part is not an official Nespresso part and does not stand in any relation to Nespresso.