New design is out. Compatibility with the multicolor upgrade is still not available
The new design should have no interference with your cable setup for the printer carriage. It also features the same design pattern as the rest of the printer.
The old design files are re-uploaded per request.
This is my custom made case for the Raspberry Pi computers for those that want to run a 3D print server like OctoPrint.
The case is mounted on the back side of the frame, just above the electronics with Z clearance in mind. The Z axis can hit the maximum level without any issues on neither the Z axis or the X carriage.
There is also a slot ready for using the Raspberry Pi camera if you want to monitor your prints.
Combined with a WiFi USB dongle this makes for a very portable printer!