Ramps 1.4 enclosure designed to mount to Vslot extrusion.
Originally designed for use on http://www.thingiverse.com/thing:1001065
Features:
-Mounting for Ramps/Arduino Controller
-60mm air intake fan
-Air exhaust vents
-Mounting for LED control board and IR sensor
-Openings for wire tubing on each side
-Flush mount lid screws
Designed to fit this Ramps/Arduino combo, which may have non-standard connector spacing, I also removed the Arduino power jack as it is not needed: http://www.ebay.com/itm/171908397844?_trksid=p2060353.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Verify before printing that this box will line up with your USB and Power connectors
Mounting Hardware Needed:
(4) M3 8mm bolt
(3) M5 10mm bolt
(3) M5 Square Nuts
(6) M5 washers
Designed to fit the following components:
Fan: http://www.digikey.com/product-search/en?keywords=259-1621-ND
Fan can be secured to plastic studs on the lid with epoxy/adhesive.
LED Control Board (removed from its enclosure with power jack removed also): http://www.amazon.com/gp/product/B00JRVSO38?psc=1&redirect=true&ref_=oh_aui_detailpage_o07_s00
WireTubing: http://www.amazon.com/gp/product/B00U8LA25O?psc=1&redirect=true&ref_=oh_aui_detailpage_o03_s00
I used the Mega standoff footprint from http://www.thingiverse.com/thing:915320