Racing style launching pad for Tiny Whoop or Blade Inductrix / clones. Launching your quad in a canted forward position allows starting at a higher speed, eliminating the need of climbing before gaining forward speed.
Features:
- Ball joint design allows pivoting up to approx. 27 degrees in any direction.
- Thin arms prevents unintentional lifting your quad by ground effect, especially from idle speed / air mode.
- Dimple shaped recesses provide just enough retention without "sinking" too deep into the launching pad.
Notes:
- Launching in extreme angle can be problematic if your quad is in Angle / Horizon / auto-leveling modes, launching in Acro / Rate is recommended, or just do the whole race in Acro, it's challenging and FUN!
- Default small_angle value in BetaFlight allows arming if your quad is canted up to 30 degrees, decrease cant angle or increase small_angle value if you have trouble with arming your quad.
- I don't have a 3D printer (yet) to do test prints or confirming fit / function, feel free to report in comment section if you encounter any problem with the design.