Inspired by Wonkey Chest of Drawers by francfalco, I just had to create a similar Bedside Table.
Designed in Autodesk Fusion 360.
Two drawers have been included:
"Drawer with built-in support.stl" has a panel across the opening to act as support when printing. This can be cut off when finished.
"Drawer needing support.stl" will need slicer supports added.
NOTE: Even though I've left 0.5 mm spacing for the drawer to fit into the bedside table, I had to scale down the drawer to 98% of its original size when printing it. You might need to do the same depending on your printer accuracy.
Please share your makes!